PS Engineering PAC24 Especificações descarregar pdf (Página 23)

PS Engineering

PAC24 Series Audio Selector Panel and Intercom System

Installation and Operator’s Manual

200-240-0010 Page 2-16 Rev. 25, Feb. 2015

2.11 Internal Recorder Checkout (Optional units only, -0200 and -0400)

With headset plugged into pilot’s side jacks, tune COM 1 to local frequency, such as FSS or ATC ground.

Select Com 1 on mic selector switch, and record at least five incoming radio transmissions.

This audio should only appear in the pilot’s headset, and only be incoming transmissions from the tran s-

ceiver selected in the mic select switch.

Depress the panel or yoke mounted playback switch, and verify that messages play, in the order received.

Repeat for other installed transceivers.

2.12 Final Inspection

Verify that the wiring is bundled away from all controls and no part of the installation interferes with air-

craft control operation. Move all controls through their full range while examining the installation to see

that no mechanical interference exists. Verify that the cables are secured to the aircraft structure in accord-

ance with good practices, with adequate strain relief. Ensure that there are no kinks or sharp bends in the

cables and coaxial cables. Verify that the cables are not exposed to any sharp edges or rough surfaces, and

that all contact points are protected from abrasion.

Complete logbook entry, FAA Form 337, weight and balance computation and other documentation as re-

quired. Sample text for FAA Form 337, and instructions for continuing airworthiness can be found in Ap-

pendix F.

Return completed warranty registration application to PS Engineering.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

Sem comentários

PS Engineering PAC24 Especificações Página 23